Installing or removing jumpers: A jumper is a small plastic encased conductor that slips over two jumper pins. Some jumpers have a small tab on top that you can grip with your fingertips or with a pair of fine needle nosed pliers. If your jumpers do not have such a tab, take care when using needle nosed pliers to remove or install a jumper; grip the narrow sides of the jumper with the pliers, never the wide sides. Gripping the wide sides can damage the contacts inside the jumper, causing intermittent problems with the function controlled by that jumper. Take care to grip with, but not squeeze, the pliers or other tool you use to remove a jumper, or you may bend or break the stake pins on the board.
Memory
The board supports only DDR
DIMMs must be installed in pairs. The furthest DIMM pair from the MCH must be populated first.
No DIMM mixing is allowed within a bank. Between banks only the DIMM size may be different. All DIMMs must be the same speed and architecture. For a list of supported memory, visit the Intel Support Web site at:
http://support.intel.com/support/motherboards/server/SE7500CW2
Aux.
Pwr DIMM 1A
DIMM 1B
DIMM 2A
DIMM 2B
OM14194
Figure 22. Installing DIMMs
66 | Intel Server Board SE7500CW2 Product Guide |
