Whirlpool 1328891 manual Power On or Off, 6th SenseTM System Control, Mode, RapidCoolTM Control

Models: 1328891

1 44
Download 44 pages 32 Kb
Page 11
Image 11
Power On or Off

NOTES:

Two AA batteries (included) power the remote control. Replace batteries after 6 months of use, or when the remote control starts to lose power.

To operate the air conditioner with the remote control, aim the remote control at the signal receptor from no more than 23 ft (7 m) away.

Power On or Off

Press POWER.

Mode

1.Press MODE repeatedly until you see the symbol glow for the desired setting.

2.Choose Cooling, Dry or Fan Only.

Cooling—Cools the room. Press AUTO, HIGH, MID or LOW to select the fan speed. Press the plus or minus TEMP button to adjust the temperature.

Dry—Dries the room. The air conditioner automatically selects the temperature. The fan runs on Low speed only.

NOTE: Dry mode should not be used to cool the room.

Fan Only—Only the fan runs. Press HIGH, MID or LOW.

If the current room temperature is lower than 73ºF (23ºC), Fan Only mode is selected automatically. Press HIGH, MID or LOW fan speed.

NOTE: Auto fan speed cannot be selected in Fan Only mode.

If the current room temperature is between 73ºF (23ºC) and 79ºF (26ºC), Dry mode and Auto fan speed are selected automatically.

If the current room temperature is higher than 79ºF (26ºC), Cooling mode and Auto fan speed are selected automatically.

1.Press 6th SENSETM system control.

2.In Fan Only mode, press HIGH, MID or LOW.

NOTE: Auto fan speed cannot be selected in Fan Only mode.

RapidCoolTM Control

Used for fast cooling. The air conditioner automatically sets the fan speed to High and the temperature to 64°F (18ºC).

1.Press RAPIDCOOLTM control. The air conditioner automatically sets the fan speed to High and the temperature to 64ºF (18ºC).

2.To turn off RapidCoolTM control, press any button on the remote control or control panel except Timer On, Timer Off and Swing.

Fan Speed

1.Choose desired fan speed.

NOTE: Auto fan speed cannot be selected in Fan Only mode.

6th SenseTM System Control

The air conditioner automatically selects Cooling or Dry mode, depending on room temperature and sets the temperature to 79ºF (26ºC).

The temperature set point can be adjusted down to 75ºF (24ºC) or up to 83ºF (28ºC). Press the plus or minus TEMP button once to change the temperature 2ºF (1ºC) or twice to change it 4ºF (2ºC).

2.Press AUTO, HIGH, MID or LOW.

Auto—automatically controls fan speed depending on current room temperature and temperature control setting.

NOTE: Auto fan speed cannot be selected in Fan Only mode.

High—for maximum cooling

11

Page 11
Image 11
Whirlpool 1328891 manual Power On or Off, 6th SenseTM System Control, Mode, RapidCoolTM Control, Fan Speed