Whirlpool 2302309 Water Filter Certifications, The water dispenser will not operate properly

Models: 2302309

1 60
Download 60 pages 58.07 Kb
Page 17
Image 17
The water dispenser will not operate properly

The water dispenser will not operate properly

WATER FILTER CERTIFICATIONS

Refrigerator connected to a water supply and the supply shutoff valve turned on? Connect refrigerator to water

supply and turn water shutoff valve fully open.

Kink in the water source line? Straighten the water source

line.

New installation? Flush and fill the water system. See “Water Dispenser.”

Is the water pressure at least 30 psi? The water pressure to the home determines the flow from the dispenser. See “Water Supply Requirements.”

Water filter installed on the refrigerator? Remove filter and

operate dispenser. If water flow increases, the filter may be clogged or incorrectly installed. Replace filter or reinstall it correctly.

Refrigerator door closed completely? Close the door firmly. If it does not close completely, see “The doors will not close completely.”

Recently removed or reversed the doors? Make sure the water dispenser wire/tube assembly has been properly reconnected at the bottom of the refrigerator door. See “Refrigerator Doors.”

Reverse osmosis water filtration system connected to your cold water supply? This can decrease water pressure. See “Water Supply Requirements.”

Water is leaking from the dispenser system

NOTE: One or two drops of water after dispensing is normal.

Glass not being held under the dispenser long enough?

Hold the glass under the dispenser 2 to 3 seconds after releasing the dispenser lever.

New installation? Flush the water system. See “Water Dispenser.”

Recently changed water filter? Flush the water system. See

“Water Dispenser.”

Water on the floor near the base grille? Make sure the water dispenser tube connections, at the bottom of the refrigerator door, are fully tightened. See “Refrigerator Doors.”

Water from the dispenser is warm

NOTE: Water from the dispenser is only chilled to 50°F (10°C).

New installation? Allow 24 hours after installation for the water supply to cool completely.

Recently dispensed large amount of water? Allow 24 hours for water supply to cool completely.

Water not been recently dispensed? The first glass of water

may not be cool. Discard the first glass of water.

Refrigerator connected to a cold water pipe? Make sure the refrigerator is connected to a cold water pipe. See “Water Supply Requirements.”

17

Page 17
Image 17
Whirlpool 2302309 warranty Water Filter Certifications, The water dispenser will not operate properly