_ .
green grounding
!&wlA II If\1 screw
Non-vented installation
Check vent baffle on top of range hood.
6.-
I
centerline
Remove terminal box cover.
Connect the white and black wires of the power supply cable to the white and black leads in the hood with
Connect the power supply grounding wire to the green, grounding wire inside the range terminal box with a
Use caulking to seal wire opening. Replace terminal box cover.
Pull firmly on tab to remove filter/light lens from range hood. Turn filter/light lens so that charcoal filter pad is facing up. Lift tabs and remove charcoal filter pad. Discard charcoal filter pad. Place edge of filter/light lens in opening so that right side is above flange and tab faces downward. Press filter/light lens into position.
2.
Remove knockout from the wiring opening (rear or top) to be used.
Do Not remove venting knockouts.
terminal box cover
Remove terminal box cover on range hood.
Personal Injury Hazard More than one person is required to help with appliance installation because of its weight and size.
Failure to follow these instructions may result in personal injury.
keyhole slot
4 L----6 i-
Lift range hood into final position and center. Mark on underside of cabinet the location for the four keyhole mounting slots. Set range hood uside on a protected surface.
cent&lineIL!
5. L
Determine and clearly mark a vertical centerline in the area the vent opening will be made.
To wire through top, mark a line
centerline
To wire through rear, mark a line
Drill a
7.
Replace terminal box cover. Continue installation with Step 13, Panel C.
/$jiiJi~~~~ij
Keep Installation Instructions
[ Congratulations! )
reference. The instructions will make reinstalling your Whirlpool
Panel D