Begin the installation
Remove racks and all other contents from oven before moving appliance. Be sure to remove all packaging material (cardboard, protective film, etc.) from range before use.
A. Remove shipping skid
.m..CARDBOARDPADS UNDER APPLIANCE
SHIPPING iKID \
,.
Remove the 4 cardboard pads from shipping box. Place them on floor as shown to protect appliance’s finish. Rest appliance (on its back) on pads.
Remove the two 318” shipping bolts from wooden skid. Discard the skid.
B. Extend leveling legs
ADJUSTABLE WRENCH
BOTTOM OF
LEVELING LEG
Once skid is removed, 4 leveling legs are exposed at bottom of frame.
Loosen legs by applying an adjustable wrench to the 1%” base of the leveling legs. Back each of them out about 4 complete turns.
Stand appliance on its base.
Begin electrical connection
Grounding Instructions
WARNING:
THIS APPLIANCE MUST BE CONNECTED TO A GROUNDED, METALLIC, PERMANENT WIRING SYSTEM, OR AN EQUIPMENT GROUNDING CON- DUCTOR SHOULD BE RUN WITH THE CIRCUIT CONDUCTORS AND CONNECTED TO THE EQUIP- MENT GROUNDING TERMINAL OR LEAD ON THE APPLIANCE.
CAUTION: Before connecting flexible armored cable for permanent wiring, disconnect power at fuse box or circuit breaker.
A. Remove terminal block cover
3/8” BRASS NUTS 3
TERMINAL
BLOCK ,
COVER
Terminal block cover is located on back of the ap- pliance near the bottom.
Remove retaining screws to expose electrical terminal block.
USE ONLY the supplied 3/8” brass nuts when connec- ting cord.
USE ONLY ring type terminals to connect cord.