7Installing optional Ll vent hood
CAUTION:
Disconnect from electrical supply before installing vent hood.
A. Spacerequired
Install vent hood BEFORE making final electrical con- nection.
When measuring, remember that leveling legs will be ad- justed. Total height needed for vent hood is
legs extended about half way.
The top of the vent hood may be installed against bottom of over head cabinets.
B. Removeknockout plug
REMOVE
IT
Position appliance so that front and back are accessible. Knockout plug is at right rear of oven top panel.
Use hammer and screwdriver as shown to remove knock- out plug.
CAUTION: Avoid damage to power supply receptacle located below knockout plug.
C. Connectvent hood
Reach through hole in bottom of vent hood, pull out power cord until all slack is removed.
Place vent hood on the top of the oven. Lift front of vent hood and connect vent hood power cord to the receptacle in the top of the oven.
Rest vent hood on the top of the oven.
VENT HOOD ORIGINAL
BACK\ ,/POSITION \
I
THIS POSITION
OVENi
BACK
Loosen screws holding the 2 mounting plates on the back of the vent hood. Rotate these plates (as shown) until the lower holes line up with matching screwholes in the
Fasten plates to the oven back using the 2 screws supplied with the vent kit. Retighten the screws that were loosened in the vent hood.
To connect ducting or to use vent hood in a ductless in-
stallation, see instructions packed with the vent hood.
See instructions packed with the vent hood for details on proper use and care.
When vent hood installation is finished, go to Step 4, “Level and position range” on page 6.