PROBLEM |
|
| CHECK IF |
|
| |
Shrlnklng | Items | are overdried |
|
| ||
| Fabric type and quality is | |||||
| suitable | for drying |
|
| ||
Slow drying | There | is a large amount | of | |||
| moisture in the load to be | |||||
| dried |
|
|
|
|
|
| Cold rinse water is used |
| ||||
| Room air temperature | is | ||||
| below 45°F (7°C) |
|
| |||
| Dryer is exhausted according | |||||
| to Installation Instructions | |||||
| Lint screen | is clogged |
|
| ||
| Exhaust | duct or outside |
| |||
| exhaust | hood is clogged |
| |||
| Proper | electrical supply | is | |||
| used |
|
|
|
|
|
Static | Load | is overdried |
|
| ||
electrktty |
|
|
|
|
|
|
| Fabric | soflener is used |
| |||
| Synthetics, | synthetic | blends, | |||
permanent press and knits are in load
CIAUSE~~LUTI~NS
Remove ittlms while there is still a trace of moisture. Some items should be removed w bile damp, then shaped and air dried.
Some knits are stretched during manufac- turing. Washing and drying returns them to the original size. This is normal. Check quality of g arment before buying. Follow
fabric care label directions carefully. I_
Some item!;; hold more moisture than others (cotlons more than polyester). They take I :)nger to dry. Full loads take longer to dr!r than small loads of the same fabric.
A load rinslt~d in cold water will take slightly lon!;ier to dry than a warm one. Cold rinses, however, help save energy and reduce wrinkling more than warm rinses do.
Install dryer in a room where the air temperatun is warmer than 45OF (7°C). Cold air inc eases drying time and may cause wrinC les not to be removed.
Install and t lxhaust your dryer according to the Installation Instructions provided.
Clean lint .s::reen before or after each use.
Clean if net+ded.
Properly col’lnect the dryer to a grounded electrical circuit that meets the electrical requiremenis stated in the Installation Instructions
Remove itelns while there is still a trace of moisture.
Use a fabric: softener and follow package
directions c: Irefully.
Synthetics, ilynthetic blends, permanent press and khlts build up static electricity. Use a fabric softener and be careful not to overdry the load.
20
