Before Using Your
Refrigerator
It is important to prepare your refrigerator for use. This section tells you how to clean it, connect it to a power source, install it, and level it.
Cleaning your refrigerator
Removing packaging materials
Remove tape and any inside labels (except the model and serial number label) before using the refrigerator.
To remove any remaining glue:
lRub briskfy with thumb to make a ball, then remove.
OR
lSoak area with liquid handdishwashing detergent before removing glue as de- scribed above. Do not use sharp instru- ments, rubbing alcohol, flammable fluids, or abras’nre cleaners. These can damage the material. See “Important Safety Instructions” on page 3.
NOTE: Do not remove any permanent instruction labels inside your refrigerator. Do not remove the Tech Sheet fastened under the refrigerator at the front.
Cleaning it before use
After removing all packaging materials, clean your refrigerator before using it, if necessary. See cleaning instructions on
Plugging | it | in |
|
| |
Recommended | Groundlng | Method |
|
| |
A 115 Volt/Go Hz (Plug l), | 220/240 Volt/50 |
|
| ||
Hz (Plug 2) or 220 Volt60 Hz (Plug 3) AC |
|
| |||
only 15 or 20 arnpere fused and properly |
|
| |||
grounded electrical supply is required. It is |
|
| |||
recommended that a separate circuit serving |
|
| |||
only this appliance be provided. Use a |
|
| |||
receptacle which cannot | be turned off with a | Plug 1 | Plug 2 | ||
switch or pull chain. Do not use an extension cord.
Plug 3
6
