Whirlpool 4YED27DQDN00 manual Things you need to know, To reinstall the doors

Removing the water line and hinges

doors without c amaging

electrical wirin 3 in the door

Things you need to know:

Two persons are needed to remove and replace the doors.

Read all directions carefully before you begin.

Tools required:

l Open-end or hex-head socket wrenches (6.5 cm [VI”] and 6 mm [W])

l 2 adjustable wrenches (or 13 mm [1/2”]and 11 mm [%‘] open-end wrenches)

l Phillips screwdriver

lKnife

Remove all door shelves and com-

partments before removing the doors.

FIGURE 2

FREEZER DOOR TOP HINGE

3.Remove the three screws that hold the top hinge. Open the freezer door and lift it up off lower hinge. Be careful not to damage the water line.

4. Reattachtherefrigeratordoor. Lift

refrigerator door onto bottom hinge pin. While holding the door in the closed position, reinstall the top hinge.

Reconnect electrical plug

FIGURE 3

FREEZER DOOR ELECTRICAL PLUG

1.Open the doors and remove the base grille at the bottom of the refrigerator. Disconnectthe union in the water line hose by remov- ing the nut at the left. Pull the tube out of the clamp. Remove the rubber “0” rings and nut from the freezer door water line and re- move the protective spring. (See figure 1.)

I Water line

Remove this nut

FIGURE 1

WATER TUBING BEHIND BASE GRILLE

2.Remove the screw that holds the upper freezer hinge cover. Dis- connect the electrical plug. (See figure 2.)

4.Carefully set the freezer door to one side. Be careful not to kink the water line hose.

5.Now, remove the refrigerator door. Pry off the hingecover, start- ing at the back of it. Hold the door while you remove thethreescrews that hold the top hinge and shim. Save the nylon spacer. Lift the door up off the bottom hinge and carefully set it aside.

NOTE: On some models, the top hinge is permanently attached to the inside of the door and must not be removed.

To reinstall the doors:

1.With the freezer door held upright next to its hinge, feed the water line carefully through the hinge hole. Lower the door onto the bottom hinge while pulling the remaining water line through the bottom. Close the door.

2.While the freezer door is still held in place, reinsert the three screws to reattach the top hinge to the cabinet. Reconnect the electrical wires at the top. (See figure 3.)

3.Reconnect the water line. Re- place the protective spring, nut, and “0” rings. Tighten the union. (Must be water tight.)

5.Align the doors and adjust the door seal. Loosen the top hinge screws and line up the doors so they are parallel with the sides of the cabinet and with each other.

To adjust the door seal, move the top hinges slightly and add shims to the bottom hinge as required. Make sure the water line and electrical wire are not interfered with.

6.Check the alignment by plugging in the refrigerator to make sure the lights go out as the doors close.

When the doors are aligned prop- erly, retighten all hinge screws se- curely and replace the hinge covers. (Replace the screw on the freezer hinge cover.) Reattach the door shelves and compartments.

Do not replace the base grille until the water line is hooked up. Check the union for leakage when water is flushed through the cold water tank. Tighten the connection if needed.

27