Barco E-2320 C (SE) system manual Installing your Barco display controller, Overview

Installing your Barco display controller

Installing your Barco display controller

This chapter will guide you through the physical installation of the display controller(s) for your BARCO Display System.

CAUTION – Wear a grounded, protective ESD strap when handling or during installation of the display controller. Electrostatic charges can damage the display controller.

Overview

Prior to installing the display controller(s) for your BARCO Display System in your PC please take a few minutes to familiarize yourself with both the display controller(s) and the PCIe slots in your computer.

Types of display controllers for Nio Display Systems

There are four different models of display controllers available for your BARCO NIO Display System.

Board Model	VGA Jumper	Recommended PCIe Slot
BARCO NIO MXRT 2100	No	x16
BARCO NIO MXRT 5100	No	x16
BARCO NIO MXRT 7100	No	x16
BARCOMED CORONIS PCIe	Yes	x8

If you are using the BARCOMED CORONIS PCIe display controller, you will need to decide if you are going to use its on-board VGA capabilities. If you are, check the setting of the Jumper at J-1 on the display controller (see figure 3). By default, VGA should be enabled, on the top two pins. To disable the on-board VGA capabilities of you BARCOMED CORONIS PCIe display controller move the jumper so that it is on the middle and bottom pins.

32