Barco E-2320 C (SE) system manual Installing your Barco display controller

Installing your Barco display controller

If you have properly installed your graphics card, the Windows start-up messages will appear once the boot procedure is finished.

Your Barco display(s) will be running in a basic video mode at a default refresh rate. Higher resolutions and refresh rates, such as 1536x2048@60Hz, are not avail- able at this stage of the installation. Once you have installed the BARCO NIO Display System drivers and soft- ware, the Barco monitor Plug and Play software should automatically set the resolution for the displays of your BARCO E-2320 C Display.

13.Install the drivers, QAWeb software and documentation for your BARCO NIO Display System by following the instructions in the section “Installing drivers and software” on page 49 of this manual.

38