Display installation
To connect the USB cable:
1.Connect the display’s USB upstream connector to the USB port of the PC by means of a USB cable.
2.Connect any USB device to any of the display’s USB downstream connectors.
Figure 15
Cable routing
Routing the signal cables
•Bind the cables in the connector compartment together with the cable tie inside the connector compartment.
•Put the connector compartment cover back on the display. Pay attention that the signal cables are positioned under the bulge in the cover.
•Push the cables into the clips on the rear of the tilt & swivel foot.
•Bind the cables together above and under the foot, by means of the 2 velcro strips attached to the inside of the foot cover (packed inside the accessory box).
•At last, put the foot cover back in place.
45
