Whirlpool 6GD25DCXHS00 Electrical Requirements, Base Grille, Do not use an extension cord, Plug

Models: 5VGS9SHGKT00 5VGS7SHGKT01 5VGS3SHGKQ01 5VGS7SHGKQ00 5VGS7SHGKT00 5VGS3SHGKQ02 5VGS3SHGKQ00 5VGS9SHGKT01 5VGS3SHGKQ03 5VGS9SHGKQ01 5VES3FHGRS00 5VGS9SHGKQ00 5VGS7SHGKQ01 6GD25DCXHS03 6GD25DCXHW02 6GD25DCXHW06 6GD25DCXHW01 6GD25DCXHW04 6GD25DCXHW05 6GD25DCXHS04 6GD25DCXHS05 6GS5SHGXRS00 6GD25DCXHS06 6GD25DCXHS00 6GD25DCXHS01 6GD25DCXHS02 6GD25DCXHW03 6GD25DCXHW00 6GD27DFXFS02

1 88
Download 88 pages 36.1 Kb
Page 5
Image 5
Electrical Requirements

Electrical Requirements

Electrical Shock HazardWARNING

Electrical Shock Hazard

Plug into a grounded (earthed) outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

Before you move your refrigerator into its final location, it is important to make sure you have the proper electrical connection:

Recommended Grounding Method

A 115 Volt, 60 Hz. (Plug 1), 220/240 Volt/50 Hz (Plugs 2 or 3), or 220 Volt/60Hz (Plug 3) AC only 10 ampere fused and grounded (earthed) electrical supply is required.

Base Grille

To remove the base grille:

1.Open both refrigerator doors.

2.Place hands along the ends of the grille, with your thumbs along the top. Push in with your thumbs and pull up on the bottom.

NOTE: Be sure to refasten the Tech Sheet behind the base grille after cleaning.

To replace the base grille:

1.Open the doors.

2.Line up the grille support tabs with the metal clips.

3.Push the grille firmly to snap it into place.

Plug 1

Plug 2

Plug 3

Plug 4

It is recommended that a separate circuit serving only your refrigerator be provided. Use an outlet that cannot be turned off by a switch or pull chain. Do not use an extension cord.

NOTE: Before performing any type of installation, cleaning, or removing a light bulb, turn the control, (Thermostat, Refrigerator or Freezer Control depending on the model) to OFF and then disconnect the refrigerator from the electrical source. When you are finished, reconnect the refrigerator to the electrical source and reset the control (Thermostat, Refrigerator or Freezer Control depending on the model) to the desired setting.

For Australia and New Zealand:

Your new appliance has been especially manufactured to meet all Australian Standards and Conditions.

Some notations in the installation instructions may refer to electrical requirements in other countries, so we draw your particular attention to these specific notes.

Your appliance needs to be plugged into a 230/240 Volt 50 Hz 10 amp (Plug 4) AC only earthed outlet.

5

Page 5
Image 5
Whirlpool 6GD25DCXHS00 Electrical Requirements, Base Grille, Electrical Shock Hazard Plug into a grounded earthed outlet