Solving problems
common dispenser/ice maker
PROBLEM
Ice dispenser won’t work
Ice dispenser stops working
CAUSE
l Freezer door open
lIce bin not properly installed
l Wrong ice in bin
l Dispenser not used for extended periods, causing ice cubes to melt together
l Ice dispenser bar held in too long
l Ice attracts airborne odors; old ice
l Water quality
lFoods not properly wrapped
l Ice bin and freezer may need cleaning
. Plumbing to ice maker
lNew ice maker
SOLUTIONS
l Close the freezer door.
lMake sure bin is pushed in all the way.
l Use only crescents from ice maker. Shake the bin occasionally to keep cubes separated and to obtain increased storage capacity.
lDump old ice and make a new supply.
l Wait about 3 minutes for the dispenser motor to reset.
l Large amounts of ice should be taken from the bin, not through the dispenser.
lDump old ice and make a new supply. Store excess ice in covered container.
l Water containing minerals (such as sulfur) may require a filter to remove.
l Wrap properly. See page 21.
l Clean freezer and ice bin. See cleaning chart on page 18.
l Follow Installation Instructions for proper ice maker water supply hook up. (See back of refrigerator cabinet.)
l The first few loads of ice from a new ice maker may have an
Removing | the base grille |
To remove the grille: | Condenser coils |
|
1.Open both doors.
2.Pull base grille forward to release the support tabs from the metal clips.
3.Do not remove Tech Sheet fastened behind the grille.
To replace the grille:
1.Line up grille support tabs with metal clips.
2.Push firmly to snap into place.
3.Close the doors.
See cleaning instructions for defrost pan and condenser coils on page 19.