Whirlpool 9.76E+13 installation instructions Operating position

Operating position

9.Move range close to cabinet opening.

10.Remove cardboard or hardboard from under range. Carefully move range into final position.

11.Pull drawer open to first stop position. Lift front of drawer to clear white wheels in drawer guides. Remove drawer and set it aside on a protected surface.

12. Make sure the anti-tip bracket is installed:

•Look for the anti-tip bracket securely attached to floor.

•Slide range back so rear range foot is under anti-tip bracket.

anti-tip bracket

range foot

13.If installing the range in a mobile home, you must secure the range to the floor. Any method of securing the range is adequate as long as it conforms to the standards in the “Mobile home installation”section.

14.Place rack in oven. Place level on rack, first side to side; then front to back.

If range is not level, pull range forward until rear leveling leg is removed from the anti-tip bracket. Use 3/8" drive ratchet and channel lock pliers to adjust leveling legs up or down until range is level. Push range back into position. Check that rear leveling leg is engaged in anti-tip bracket.

NOTE: Oven must be level for satisfactory baking conditions.

15.Replace the storage drawer or lower panel.

16.Reconnect power.

8