CommonDishwashingProblems
Spotting and filming (hard water film) Hard water
Fill detergent dispensers to capacity. Use dishwasher detergent with highest available phosphorus content. May be necessary to install water softener.
To remove spots and film, try a vinegar rinse...
1.Wash and rinse load as usual. Use Air Dry Option.
2.Remove all metal items.
3.Put 2 cups (500 mL) white vinegar in a container on the bottom rack.
4.Run dlshwasher through a complete washing cycle.
Water is not hot enough
Water temperature should be at least 140°F (60°C). Set water heater thermostat to a higher setting, Run water at sink until hot before starting and/or use
Not enough detergent, or improper detergent
Use more dishwasher detergent. Use detergent with highest available phosphorus con-
tent.. .espeaally with hard water.
“Old” detergent
Use only fresh dishwasher detergent. Store tightly closed container, in cool, dry place. Discard old detergent. Do not fill dispensers until ready to start dishwasher.
Improper loading
Make sure dishes and glassware are loaded so spray reaches all surfaces and items drain properly. Do not overload. Do not nest Items.
Make sure large items do not block spray from reaching detergent dispensers.
No rinse agent
Does the rinse agent’dispenser need filling? See instructions on page 15.
AIR DRY Setting used
Drying without heat may result in some spotting of glasses and silver.
Small particles deposited on items Spray arm or arms not rotating freely
Check spray arms to make sure they turn freely after loading. Be sure a utensil has not prevented their turning.
“Old” detergent
Use only fresh dishwasher detergent. Store tightly closed container, in cool, dry place. Discard old detergent. Do not fill dispensers until ready to start dishwasher.
Not enough detergent, or improper detergent
Use more dishwasher detergent. Use detergent with highest available phosphorus content.. especially with hard water.
Water is not hot enough
Water temperature should be at least 140°F (60°C). Set water heater thermostat to a higher setting. Run water at sink until hot before starting and/or use
Water pressure may be low, dishwasher is not filling properly
If water pressure is low, do not use water for other purposes while dishwasher is running (to assure correct fills).
Dishes not dry No rinse agent
Does the rinse agent dispenser need filling? See instructions on page 15.
Water is not hot enough
Water temperature should be at least 140°F (SPC). Set water heater thermostat to a higher setting. Run water at sink until hot before starting and/or use
Improper loading
Make sure dishes and glassware are loaded SOspray reaches all surfaces and items drain properly. Do not overload, Do not nest items.
AIR DRY Setting used
Allow more time when using Air Dry Option, or use Heat Dry Option. Plastic items may need towel drying.
Black marks on dishes
Aluminum utensils rubbing against items during washing
Use care in loading aluminum utensils,
especially any lightweight foil container. PlaceSO thgy do not touch dishes. Remove black marks with plastic scounng pad and a mild abrasive cleanser.
Chipping or breaking glassware Improper loading
Do not overload. Load glasses in the top rack only. Load between prongs, not over them. Glasses loaded over prongs will not be supported and may chip or break.
18
