Whirlpool 9200 SERIES manual Delaying a wash, TheCANCEL/DRAINpad, Usin$ cycle pause

Delaying a wash

The DELAY pad allows you to delay the start of a cycle for 2 hours after loading the dishwasher. For example, use the DELAY to run the dishwasher during off-peak hours of electrical use.

1.Press the DELAY pad once to display the last cycle and options, selection.

2.Select a new cycle and option(s), if desired.

3.Press the DELAY pad again to select a 2-hour delay. The 2 HOURS signal light will come on.

NOTE: Immediately pressing the DELAY pad again WIIIcancel the selection. If no delay is selected, the 2 HOURS signal light will be off.

4.After 2 hours, the signal light WIIIturn off and the dishwasher will start.

NOTE:

lYou may press the START pad at any time during the delay if you want the dishwasher to start immediately.

l You may press the CANCEL/DRAIN pad to cancel the delay and clear the delay signal light.

lYou may add items to the load at any time during the delay. Close the door firmly to latch it.

TheCANCEL/DRAINpad

The CANCEL/DRAIN pad allows you to cancel

a cycle, to clear the signal lights or lo make a new selection. If the dishwasher is washing, it will go into a 2-minute drain automatically before shutting off. Pressing CANCEL/DRAIN again stops the drain. If the dishwasher had not been started or is not washing, it will clear the display. Pressing CANCEL/DRAIN again will start a 2-minute drain, if needed.

Usin$ cycle pause

A cycle can be stopped at any time for up to 10 minutes.

1.Press the DELAY pad. Any signal lights lhat are on will flash slowly until the cycle restarts after 10 minutes.

2.The cycle can be started sooner by pressing the START pad.

5