TheWATERHEATINGsignal light
The WATER HEATING signal light comes on during the water heating portions of the Pots 8 Pans Cycle. The signal light will also come on during the water heating portion of other cycles when the
The WATER HEATING signal light will flash at the end of the cycle if the water did not heat to 140°F (60%). If you want to make sure the water gets heated to 140°F (SO’C), use the
When the signal light is on, water is being heated. The heating time is based on the tempera- ture of the water supply as it enters the dish- washer. The cooler the water, the longer the heating time. The WATER HEATING signal light will go off when the water temperature reaches 140°F (SOOC).
TheCLEANsignal light
The CLEAN signal light comes on at the end of a cvcle to show that the load IS clean. It will stay on until CANCEL/DRAIN or any other control pad is pressed.
As an option, you can have the CLEAN light turn off the first time you open the door after a cycle
is finished:
1. Press and hold the CYCLE pad until the
| CLEAN signal light starts flashing. |
| 2. Release the pad. The CLEAN signal light will |
| turn off. |
| NOTE: A power failure will reset this feature. You |
C | will have to redo the above steps. |
To again have the signal light stay on when the | |
door is opened: | |
1. Press and hold the CYCLE pad until the CLEAN | |
signal light turns on. | |
| 2. Release the pad. The CLEAN signal light will |
| turn off. |
7
