The WATER HEATING signal light
The WATER HEATING signal light comes
on during the water heating portion of the
Pots 8 Pans cycle. The signal light will also
come on during the waterheating portion of
other cycles when the Hi-Temp option is
selected.
The WATER HEATING signal light will
flash at the end of the cycle if the water did
not heat to 135°F (57°C). lf you want to
make sure the water gets heated to 135°F
(579 use the Hi-Temp option (see
page 13).
When the signal light is on, water is being
heated. The heating time is based on the
temperature of the water supply as it enters
the dishwasher. The cooler the water, the
longer the heating time. The WATER
HEATING signal light will go off when the
water temperature reaches 135°F (57°C).
The CLEAN signal light
The CLEAN signal light comes on at the end
of a cycle to show that the load is clean. It
will stay on until CANCEUDRAIN or any
other wntrol pad is pressed.
As an option, you can have the CLEAN
light turn off the first time you open the door
after a cycle is finished:
1. Press and hold the CYCLE pad until the
CLEAN signal light starts flashing.
2. Release the pad. The CLEAN signal light
will turn off.
NOTE: A power failure will reset this feature.
You will have to repeat the above steps.
To have the signal light stay on again when
the door is opened:
1. Press and hold the CYCLE pad until the
CLEAN signal light turns on.
2. Release the pad. The CLEAN signal light
will turn off.
PRESS YOU SEE
PRESS YOU SEE
A q - 10