PROBLEM CHECK THE FOLLOWING
White residue appears Is
too much detergent being used? See pages 14 and 15 for
on front of access
recommended amounts of detergent.
panel
Some liquid detergents develop excess foam and build up on
access panel. Try
a
different brand to reduce foaming and
eliminate build-up.
WATER HEATING
Is the water supply less than 120°F (49°C) when it enters the
signal light flashes
dishwasher? See pages 10 and 17.
Control panel does not Is
the door open?
work
Is the cycle pause feature on? See page 7.
Is the control panel lock-out feature
on? See page 9.
All signal lights flash
Has there been a power failure? See page 11.
and the dishwasher
stops or will not run
Control panel does not Is
the control panel lock-out feature on? See page 9.
“beep” when pads are
pressed
Dishwasher drains
after turning off
CLEAN signal light
and/or closing the
door
Did you accidentaly press the CANCEWRAIN pad while
closing the door’? Press CANCEUDRAIN pad again to stop
draining. Restart cycle if needed.
28