Whirlpool 9400 warranty Changing a cycle setting, Adding a dish during a cycle, During, Cycle

Changing a cycle setting

You can change a setting anytime during any cycle.

During	the	first	minute	of a
cycle
During the first minute of a cycle the dish-
washer is filling with water and the wash
action has not started.					SELECT
1. Select	a new	cycle	and option(s).
2. Be sure the detergent dispensers are
filled properly for the new cycle.					m
After the first			minute	of a
cycle:					PRESS
1. Press	the CANCEL/DRAIN			pad. The
dishwasher will go into a 2 minute drain
cycle,	if needed.				m D- 1
2. Select	a new	cycle	and option(s).		SELECT
3. Be sure the detergent dispensers are
filled properly for the new cycle.					m
4. Press	the START		pad. The	dishwasher	PRESS
will start the new cycle.

.*. w

wa. l

Adding a dish during a cycle

You can add an additional item to the dishwasher anytime while the ADD A DISH signal light is on.

1.Lift up on the door latch to unlatch the door and stop the cycle. Wait a moment for the spray action to stop before open- ing the door.

2.Open the door and add the dish.

3.Close the door. Do not latch it. Wait

30 seconds for air in the dishwasher to warm up. This helps reduce the amount of moisture that can come from the vent when restarting the cycle.

4.Press door in to latch it. The dishwasher will start where it stopped.

NOTE: The cycle will be cancelled if you accidentally touch the CANCEL/DRAIN pad while closing the door. Press the CANCEU DRAIN pad again, then press the START pad to restart the cycle.

8