Whirlpool ACE184XM0 manual Chart-C, Receptacle Wiring, Electrical Requirements

RECEPTACLE WIRING

RECEPTACLE WIRING should be at least as large as size shown on electrical Chart B. Use copper wire only. It is the personal responsibility and obligation of the customer to provide proper and adequate receptacle wiring installed by a

qualified electrician. OBSERVE NATIONAL

ELECTRICAL CODE AND ALL LOCAL

GOVERNING CODES AND ORDINANCES.

RECOMMENDED GROUNDING METHOD

For your personal safety, this appliance must be grounded. This appliance is equipped with a power supply cord having a 3-prong grounding plug. To minimize possible shock hazard, the cord must be plugged into a mating 3-prong grounding type wall receptacle, grounded in accordance with the National Electrical Code and local codes and ordinances. If a mating wall receptacle is not available, it is the personal responsibility and obligation of the customer to have a properly grounded 3-prong wall receptacle installed by a qualified electrician.

A separate electrical supply is required on a separately fused circuit. Do not fuse ground- neutral.

See Chart C for receptacle voltage require- ments, proper fuse size, wire and wiring con- nections which must conform with rating of the appliance. Do not use an extension cord.

Chart-C

	RECEPTACLE
PLUG AND	VOLTAGE
RECEPTACLE	(60	HERTZ	SERIAL PLATE
DATA	AC	IN ALL	AMPERES

ELECTRICAL REQUIREMENTS

USE TIME-DELAY
FUSE		TYPE
OR TIME	MINIMUM
DELAY CIRCUIT	RECEPTACLE	OF BRANCH
BREAKER	WIRE SIZE	CIRCUIT
RATING IN
AMPS

For 230 volt and 230/208 volt models with serial plate amperes up through 16.0

Refer to Chart C for specific wiring and recep- tacle information to be used.

OBSERVE ALL LOCAL GOVERNING CODES AND ORDINANCES.

Do not, under any circumstances, remove the power supply cord ground plug.

ELECTRICAL GROUND IS REQUIRED ON THIS APPLIANCE.

A three-wire, single-phase 60 hertz AC only electrical supply is required.

RECEPTACLE WIRING

RECEPTACLE WIRING should be at least as large as size shown on electrical Chart C. Use copper wire only. It is the personal responsibility and obligation of the customer to provide proper and adequate receptacle wiring installed by a

qualified electrician. OBSERVE NATIONAL

ELECTRICAL CODE AND ALL LOCAL

GOVERNING CODES AND ORDINANCES.