Installation Instructions
Continued
deep filler panel
| back cover |
sleeve | (outdoor side) |
front cover (indoor side)
3.Measure wall sleeve depth. If sleeve is more than 18" deep, remove condenser baffle. Use the 2 screws from the condenser baffle to attach the deep filler panel in place of the condenser baffle.
4.Slide the air conditioner into the sleeve until the condenser baffle (or deep filler panel, if installed) contacts the exterior grille.
Continue installation with steps
Installing in a new sleeve
1.Remove the front and back covers. Save these for future use to seal the sleeve if the air conditioner is removed.
2.Remove the rear grille from the sleeve.
3.Brush out all debris from inside the sleeve, making sure the inside is clean and that the drain holes are completely open.
4.Loosen screws in the rear grille to about 1⁄8". Then, while holding on to the wire loop, tip the grille and pass it through the rear opening of the sleeve. The baffle contact area should be on the left.
8
