PORTABLE INSTALLATION INSTRUCTIONS
Drain System
The washer must drain into a sink or laundry tub with a carry- away capacity of 7 gal. (26.6 L) per minute (for portable installations). The top of the tub must be at least 27" (68.6 cm) above floor and no higher than 48" (121.9 cm) from the bottom of the washer.
27"
(68.6 cm)
Connect Fill-And-Drain Hose
Proper connection of the
Connect Drain Hose
To prevent the
IMPORTANT: To ensure proper installation, this procedure must be followed exactly.
1.Wet inside end of the
2.Squeeze ears of
¼" (6 mm) from the end. Twist hose back and forth while pushing down onto drain connector at the bottom of the washer. Continue until hose contacts the cabinet.
¼"
(6 mm)
3.Place clamp over area marked “CLAMP.” Release clamp.
Insert new flat washer (supplied) into the end of the inlet hose. Firmly seat the washer in the coupling.
¼"
A
AB
A.Coupling
B.Washer
Connect Fill Hose
Attach the
NOTE: Do not overtighten. Damage to the valves can result.
Hot water (right) inlet valve is capped. Leave this valve capped.
(6 mm)
B
¼"
C (6 mm)
A.Drain hose
B.Clamp
C.Cabinet
Attach Faucet Adapter Kit
Proper connection of your faucet adapter kit will allow hot and cold water to enter your washer properly. It also helps prevent water damage due to leaks.
Attach the faucet adapter kit from the parts bag to your faucet. A standard faucet adapter and washer are supplied. Customized adapters are available from traditional plumbing supply sources.
A
B
A.Washer
B.Adapter
10