INSTALLLOOSEPARTS
ICE THICKNESS
.
REAR MOUNTING
PIN
- DEFLECTOR
FLOAT WATER LEVEL
ADJUSTMENT / \’ ’ ;;lER PUMP
SPRING
FRON T hhl3UNTING BOLT
OVER PINS
The following loose parts packed InsIde Ihe head WIII have to be field Installed
1.Water Pump Pan. Hold pan so the gradua!ly sloped area IS at left Place the left 11p edge between the lower
evaporator and on the top of the entering edge of the lower cutter grid Raise right end of water pan and place pan flange on angle bracket attached to right liner wall Remove packing holding the float valve for shlpplng
2.Drain Line for Water Pump Pan. The formed piece of white vlnyl tubing slips over the pump pan drawn tube and the drain lube going through the back wall of the
storage bin or on a field constructed bin run to an open drain.
NOTE: The 1/8”dia siphon break hole must be In IIle vertical leg of white vinyl tubing
CAUTION: | Insufficient | or | continuous | siphoning | may | |||
result | from: |
|
|
|
|
|
|
|
a. | Reducing | the | inside | diameter | of | the drain | line. | |
b. | Having | less than | l/4” | per | foot | fall, |
|
|
c. | Traps or extreme | bends in the lines. |
|
| ||||
3. Cube Deflector. | Flex cube | deflector | baffle | so | that it |
hangs from pins. | Top edge will | rest | against | cutter | grid |
frame |
|
|
|
|
|
4. Ice Level Control Baffle. The ice level baffle must be installed at the bottom left end of the ice maker head with the curve inward. Slip the hole in the baffle over the pin in the back liner wall. Raise up front edge and fasten through lower support rail by removing and reinserting screw pro- vided. Install spring from baffle to right hand hole in lower support rail to hold baffle off switch plunger. Weight of ice against baffle will operate switch.
APPROX. 318” +I”-
|
|
|
|
|
|
| SWITCH |
| |
|
|
|
|
|
|
| TAB |
|
|
|
|
|
|
|
|
| CONTROL |
| |
|
|
|
|
|
|
| SPRING |
| |
NOTE: | Baffle | must | swing | freely | without | binding. |
| ||
5. | Let | Baffle | Hang | Vertically. | Move | baffle | slowly | to left | |
and | listen for | bin switch | “click” | to determine | that | switch | |||
will turn machine “ON” and “OFF.” (Adjust switch tab until switch operates.)
5
