Whirlpool DU8lOOXX manual Toadda dishafterstarting, Changing cyclesetting

Operating Instructions

Continued

star-l and stop as the knob passes each cycle mark. This is normal and will not hurt the dish- washer. If you prefer, you can set cycles with the door unlatched.

Toadda dishafterstarting

1. To be sure the added item is washed and rinsed, make sure the Cycle Control Knob has not passed LIGHT WASH.

2. Lift up on the door latch to unlatch door and stop the cycle. Don’t open the door until the spray arms stop spinning.

3. Open the door and add the dish.

4. Close the door. Do not latch it. Wait 30 seconds for air in the dishwasher to warm up. This helps reduce the amount of moisture that can come from the vent when restarting the cycle.

5. Press door in to latch it. The dishwasher will slart where it stopped.

Changing cyclesetting

You can change a setting anytime during any cycle.

1. Lift up on the door latch to unlatch the door and stop the cycle.

2. Turn the Cycle Control Knob clockwise to the cycle you want.

3. Be sure the detergent dispensers are filled properly for the new cycle. When changing dial from LIGHT WASH to NORMAL WASH setting, detergent is released. Reload covered section of dispenser before starting Normal Wash Cycle.

4. Close and latch the door. The dishwasher will automatically start the new cycle.