VacationandMovingCare
Electrical Shock Hazard
Make sure the ice maker is disconnected from the main power supply before remov- ing lower access panel. Failure to do so could result in electrical shock or personal iniurv.
To shut down the ice maker:
1. Disconnect electrical power supply to the ice maker and turn the Cycle Control Knob to “OFF.”
2. Remove all ice from storage bin.
3. Shut off the water supply.
4. Remove two screws from grille area of lower access panel, then remove the panel.
5. Disconnect the inlet and outlet lines to water valve. Allow these lines to drain and then reconnect to the valve.
6. Replace lower access panel and screws.
7. Remove water from drain lines and drain water pan.
8. Before using again, clean the ice maker and storage bin.
NOTE: All components of the ice maker are permanently lubricated at the factory. They should not require any additional oiling throughout the normal life of the machine.
13
