Whirlpool EC510 manual Settingthe controls, Changingthe bin doorpanel

Using Your Ice Maker

Continued

Settingthe controls

1. Select ice thickness. The ice maker has been pre-set to produce ice approximately l/2” (13 mm) thick, while operating in a room temperature of 70°F (21°C).

Operation in different room temperatures may require readjusting the control toward “THICK” or “THIN.”

Best operation will be obtained with ice l/2” (13 mm) to 5/6” (16 mm) thick.

If operating in a warm room (above 90°F [32”C]) DO NOT set control to maximum thickness or the unit may malfunction.

2. To start the normal ice making cycle, turn the Cycle Control Knob to “ON.”

3. To stop ice maker operation, turn Cycle Control Knob to “OFF.”

The “CLEAN” setting is used whenever solutions are circulated through the ice maker for cleaning. Only the water pump operates at this setting. See “Cleaning the ice maker system” on page 9 for specific instructions.

Changingthe bin doorpanel

You can easily change the color of the front panel on the storage bin door. Two colors are available: Black and White.

To change panel:

1. Open the storage bin door. Remove the two screws on the top of the door, which hold the handle.

2. Loosen the screws in both of the side trim pieces.

3. Remove the handle and the handle insert.