Using Your Ice Maker
Continued
3. Carefully slide the panel out.
4. Choose the color you want to show and carefully slide the panel back into the lower access panel.
NOTE: Be careful not to scratch the panel as it is inserted.
5. Replace the top trim and screws. Replace the
lower access panel assembly and screws.
NOTE: You can make a decorative wood front to match existing cabinets. The panel should be l/4” (6 mm) thick and 17” x 11 ‘5/~6”
(433 mm x 303 mm). Remove the color panel and spacers to allow for wood thickness.
Changingthe light bulb
1 . . Elecrl She; Hazard
Before removing the light bulb, either unplug the ice maker or disconnect the electnclty leadlng to the Ice maker at the main power supply. Shock and injury can occur if electricity remains connected.
The ice maker has a light bulb in the top of the storage bin. To replace it, open the bin door and follow these instructions:
1. Disconnect ice maker from power supply.
2. Remove the two thumb screws and slide the ice cutter grid forward, out of the two slots near the water pan. Set the ice cutter grid on the bin door.
Light switch
3. Press the front of the light shield in while pulling down to remove it from the light bracket.
