Whirlpool ED20HK, ED20GK manual Raise signal arm to stop ice

Raise signal arm to stop ice

Lower signal arm to start it

Ice cube trays

If cubes are not used, they may shrink. The moving cold air starts a slow evaporation. The longer cubes are stored, the smaller they get.

To remove ice:

1.Hold tray at both ends.

2.Twist slightly.

Automatic ice maker

If you have the automatic ice maker accessory, or if you plan to add one later (Part No. ECKMF-90), there are a few things you will want to know:

l The ON/OFF lever is a wire signal arm. Down.. .for making ice automatically. Up.. .to shut off the ice maker.

NOTE: Do not turn ice maker on until it is con-

nected to the water supply. Instructions for ice maker water supply hook-up are attached to the back of the refrigerator

cabinet._.

. The dial or lever on the side of the ice maker changes the size of the cubes.

l Shake the bin occasionally to keep cubes sepa- rated, and to obtain increased storage capacity.

lIt is normal for ice crescents to be attached by a corner. They will break apart easily.

l You will hear water running when ice maker is working. You’ll hear ice fall into the bin. Don’t let these sounds bother you.

l The ice maker will not operate until the freezer is cold enough to make ice. This can take overnight.

l Because of new plumbing connections, the first ice may be discolored or off-flavored. Discard the first few batches of ice.

lIf ice is not being made fast enough and more ice is needed, turn the Refrigerator Control toward a higher number. Wait a day and, if necessary, turn the Freezer Control toward C.

lIf you remove the ice bin, raise the signal arm to shut off the ice maker. When you return the bin, push it all the way in and lower the arm to the ON position.

lIf cubes are stored too long, they may develop an off-flavor.. like stale water. Throw them away. Ice maker will make new ice. Cubes in the ice bin can also become smaller by evaporation.

l Good water quality is important for good ice quality. It is not recommended that the ice maker be connected to a softened water supply. Water softener chemicals such as salt from a malfunc- tioning softener can damage the ice maker mold and lead to poor quality ice. If a softened water supply cannot be avoided, then it is important that the water softener be well maintained and operating properly.

9