Whirlpool ED25PS Install properly, Level refrigerator-freezer, Remove sales labels, Clean it

Models: ED25PS

1 20
Download 20 pages 33.99 Kb
Page 4
Image 4
Install properly.. .

Install properly.. .

1.Allow Yz inch (1.25 cm) space on each side and

at the top of the refrigerator for ease of installation.

2.If the refrigerator is to be against a wall, you might want to leave extra space so the door can be opened wider.

3.The refrigerator back can be flush against the wall.

Level refrigerator-freezer.. .

TO ADJUST

FRONT ROLLER

I I

VELLING SCREW

IGHT TO RAISE;

LEFT TO LOWER

1.Remove base grille (see page 9).

2.To raise front, turn screw in direction shown.

3.To lower front, turn screw in the direction shown.

4.Check with level.

Remove sales labels.. .

Remove the Consumer Buy Guide label, tape and any inside labels before using the re- frigerator. To remove any remaining glue:

1.Rub briskly with thumb to make a ball then remove.

OR

2.Soak area with liquid hand dishwashing detergent before removing glue as described in step I.

DO NOT USE rubbing alcohol or flammable or toxic solvents, such as acetone, gasoline, car-

bon tetrachloride, etc. These can damage the material.

NOTE: DO NOT REMOVE ANY PERMANENT IN- STRUCTIONS LABELS INSIDE YOUR REFRIGER- ATOR.

Do not remove the Tech sheet fastened under the refrigerator at the front.

Clean it...

Clean your refrigerator before using it. See cleaning instructions on page 13.

Plug it in...

3-PRONG GROUNDING TYPE WALL RECEPTACLE

REFRIGERATOR

3-PRONG

 

 

 

POWER CORD

 

GROUNDING

PLUG

 

A 115 Volt,

60 Hz., AC only

15 or 20 ampere

fused

and properly

grounded

 

electrical

supply

is re-

quired.

It is recommended

 

that

a

separate

circuit

serving

only

this appliance

be

provided.

 

Do not use an extension cord. Use a recepta- cle which cannot be turned off with a switch or pull chain. See individual electrical requirements and grounding instructions sheet in your literature package.

The ON/OFF switch (inside the freezer door just above the ice dispensing slot) should be set to ON before you plug the refrigerator in for the first time. The refrigerator temperature is preset to 36°F (2”C), the freezer to 0°F ( - 18°C).

Turn off beeping...

The warm refrigerator and freezer temperature warnings will beep eight times every two minutes when the refrigerator is first plugged in. To turn beeping off until refrigerator and freezer reach normal temperatures press and hold the RESETPad until two beeps are heard [see Display Mode, page 51.

Page 4
Image 4
Whirlpool ED25PS Install properly, Level refrigerator-freezer, Remove sales labels, Clean it, Plug it in, Turn off beeping