Electronic control center TEMPERATURETEMPERATURE
SIGNAL |
|
| LIGHTS | / DISPLAY |
| |
|
|
|
|
|
| |
LIGHT |
|
|
|
|
|
|
POWER |
|
|
|
|
| |
SAVER | PAD |
|
|
|
|
|
|
| I |
|
| DISPLAY | WARNING |
AUTO |
|
|
| SIGNAL | LIGHTS | |
|
|
|
| |||
TEMP |
|
|
|
|
| |
FRMCE | PAD |
|
|
|
|
|
|
|
|
|
| TEMPERATURE | |
|
|
|
|
| ADJUSTING PADS | |
NIGHT | / | ICE “/ | ‘FRZ TEMP | ‘REF TEMP | ‘SET |
|
LIGHT | PAD’ | SELECTION PADS | PAD | PAD | TEMP PAD |
|
A beep will be heard each time a control pad is pressed. The signal light on a control pad will come on when that control is first pressed.
Display mode...
The display mode is used to demonstrate the Electronic Control Center. Using the display mode will also turn off the beeping from the warning signals. The refrigerator will continue to operate normally while the Electronic Control Center is in the display mode.
To start the display mode, press and hold the RESETPad until two beeps are heard. While in the display mode, the five signal lights will flash. Press- ing the control pads during the display mode will not change any settings. However, if a control pad is pressed, you will hear a beep and the signal light will come on.
To cancel the display mode press the RESETPad
once. The display mode will automatically cancel after being on for 8 hours.
NOTE: If the display mode is entered while the ON/OFF switch is OFF, “CO” will show on the dis- play. You must set the ON/OFF switch to the ON position before the refrigerator will start cooling.
Power saving pad...
The POWER SAVER Pad on the Electronic Control Center operates low wattage electric heaters around the door openings. These heaters keep moisture from forming on the outside of the re- frigerator when the humidity is high.
1 When humidity is low, press the POWER SAVER Pad to turn the Power Saver signal light on. This will turn off the heaters.
2.If moisture forms on the outside of the refrigerator, press the POWER SAVER Pad to turn the Power Saver signal light off. This will turn the heat- ers on.
Setting the temperatures...
When the refrigerator is first plugged in, the
freezer temperature is preset to 0°F (
Give the refrigerator time to cool down com- pletely before adding food. (This may take sev- eral hours).
These settings should be about right for nor-
mal household refrigerator usage.
The temperatures will be set about right when milk or juice is as cold as you like and ice cream is firm.
If you need to adjust temperatures in the re- frigerator or freezer do the following:
l Adjust the refrigerator or freezer temperature. l Wait at least 24 hours,
l If needed, make further temperature adjust- ments to the refrigerator or freezer.
continued on next page
5