Ice and cold water dispenser...
FOR ICE: | FOR CHILLED WATER: |
Press a sturdy glass against the ice dispenser bar. (Pres- sure and tumbling ice can break a fragile glass.]
The first few batches of ice from the ice maker may have a bad taste from new plumb- ing and parts. Throw them away.
Press a sturdy glass against
the water dispenser bar. (Pressure can break a fragile glass.] Remove the glass to stop dispensing.
Dispense enough water
every week to maintain a fresh supply.
PRESS AGAINST
ICE DISPENSER BAR
The small tray beneath the dispenser is deslgned to evaporate small spills. There is not drain in this tray. Do not pour water into it.
Chilled water comes from a tank behind the meat drawer. It holds about 50 ounces (1.5L).
When the refrigerator is first hooked up press the water dispenser with a glass or jar until you have drawn and discarded 2 or 3 quarts (1.9 to 2.8L).
The water you draw and discard will rinse the tank and pipes.
Allow several hours to chill the first tankful.
Ice is dispensed from the ice maker storage bin in the freezer. When the dispenser bar is pressed, a trapdoor opens in a chute between the dispenser and the ice bin. Ice is moved from the bin and falls through the chute. When the trapdoor closes, a faint buzzing sound may be heard for a few seconds.
The MIN/MED/MAX and CONT Pads control the amount of ice dispensed at one time. Select the setting that meets your family’s needs.
The CONT setting will dispense ice as long as the Ice dispenser bar is held.
NOTE: Large amounts of ice should be taken from the bin, not through the dispenser. The MAX FRZ/ICE setting can be used for maximum ice production.
To set the ice control:
1.Press the Ice Selection Pad forthe amount of ice you want. The signal light on the pad will come on briefly
2.This amount of ice will be dispensed each time the ice diSDenSer bar is Dressed. Press another Ice Select& Pad to cha’nge the setting
Common Problems
PROBLEM
Dispenser won’t work.
Ice dispenser won’t work.
Ice dispenser stops working.
CAUSE
Freezer door open
Ice bin not properly installed Wrong ice in bin.
Ice dispenser control set on MI~w MED or MAX.
Ice dispenser bar held In too Ic g
Ice attracts airborne odors.
Old ice.
Water quality
Foods not properly wrapped.
Ice bin and freezer may need cleaning.
Plumbing to ice maker
New ice maker
SOLUTION
l Close the freezer door.
l Make sure bin IS pushed all the way in
l Use only ice crescents from ice maker. Other shapes won’t dispense properly.
* Select CONT setting
l Wait about 3 minutes for the dispenser motor to reset.
. Large amounts of Ice should be taken from the bin. not through the dispenser.
*Use rapidly or store in covered container
l Dump old ice and make new supply.
l Water containing minerals (such as sulfur] may require a filter to remove.
l Wrap properly. See pages 15 and 16.
0 Clean freezer and ice bin. See Cleaning Chart on page 13.
l Follow installation instructions for proper ice maker water supply
=The first few loads of ice from a new ice maker may have an
