Whirlpool ED26MM manual Install, properly, Remove sales labels, Clean it, Plug it in

Models: ED26MM

1 20
Download 20 pages 32.86 Kb
Page 4
Image 4
Install

Install

properly..

.

.

I.Allow %” (.2 cm] space on each side and at top for ease of installation.

2.The refrigerator back can be flush against the wall.

3.If the refrigerator is to be in a corner, keep 1% inches (3.1 cm] between the wall and side of the

refrigerator so there is room to open the SERVA-DOOR” or to clear the ice and water dispenser.

Remove sales labels.. .

Remove the Consumer Buy Guide label and other insrde labels before using the refrigerator. Any glue left can be taken off with rubbing alcohol.

Clean it.. .

Clean your refrigerator before using it. See clean- rng Instructions on page 9.

Plug it in...

grounding type wall receptacle

Level refrigerator-freezer.. .

Front Roller

Right to Raise;

Left to Lower

I, Remove base grrlle [see page 9 1,

2.To raise front, turn each screw to the right.

3.To lower front, turn each screw to the left.

4.Check with level.

Refrigerator

Power Cord

Recommended

Grounding Method

A 115 Volt, 60 Hz., AC only, 15 or 20 ampere fused electrical supply is required. It ISrecommended that a separate circuit serving only this appliance be provided.

Do not use an extension cord. Use a receptacle which cannot be turned off wlth a switch or pull chain. See individual electrical requirements and

grounding instruction sheet in your literature package

4

Page 4
Image 4
Whirlpool ED26MM manual Install, properly, Remove sales labels, Clean it, Plug it in, Level refrigerator-freezer