4.On models with notches:
■Slide the indicator down into the notches, facing outward.
NOTE: The indicator will not easily slide into the notches if the rear bubble has not been popped.
■Close the air filter door, and check that the indicator is visible through the rectangular hole in the door.
On models without notches:
■Store the indicator in a visible place you will easily remember - either inside the refrigerator, or elsewhere in your kitchen or home.
Replacing the Air Filter
The disposable air filter should be replaced every 6 months, when the status indicator has completely changed from white to red.
To order a replacement air filter, see “Accessories.”
1.Remove the old air filter by squeezing in on the side tabs.
2.Remove the old status indicator.
3.Install the new air filter and status indicator using the instructions in the previous sections.
Install Produce Preserver
(on somemodels)
On some models, your refrigerator's accessory packet includes a Produce Preserver, which should be installed prior to use. On some models, the Produce Preserver is already installed at the factory.
The Produce Preserver absorbs ethylene, allowing the ripening process of many produce items to slow down. As a result, certain produce items will stay fresh longer.
Installing the Produce Preserver (on some models)
CAUTION: IRRITANT
MAY IRRITATE EYES AND SKIN. DANGEROUS FUMES FORM WHEN MIXED WITH OTHER PRODUCTS.
Do not mix with cleaning products containing ammonia, bleach or acids. Do not get in eyes, on skin or clothing. Do not breathe dust. Keep out of reach of children.
FIRST AID TREATMENT: Contains potassium permanganate. If swallowed, call a Poison Control Center or doctor immediately. Do not induce vomiting. If in eyes, rinse with water for 15 minutes. If on skin, rinse with water.
The Produce Preserver pouches should be installed in their housing, which is located along an interior side wall of the crisper or convertible drawer.
|
| . | |
ATTENTION |
| revers | |
| le | ||
| sur | ||
T | |||
prudences | |||
N | |||
| ITA |
| |
| R |
| |
| IR |
| |
|
| des | |
|
| Lisez | |
|
| . | |
CAUTION | back | ||
Read | |||
|
| T on | |
|
| N | |
|
| IR cautions | |
|
| ITA | |
|
| R | |
NOTE: For best performance, always use two pouches.
1.Remove the Produce Preserver pouches from their packaging.
CAUTION | ATTENTION |
IRRITANT | IRRITANT |
Read cautions on back. | Lire les mises en garde au dos. |
Whirlpool Corporation, Benton Harbor MI 49022
2.Lift up on the housing in order to remove it from its mounting tab along the wall.
3.Open the housing by pulling up and out on the back of the top of the housing.
4.Place both pouches inside the housing, then snap the housing back together.
5.Place the housing back on the mounting tab along the wall.
Installing the Status Indicator (on some models)
The Produce Preserver comes with a status indicator, which should be activated and installed at the same time the pouch is installed.
REPLACE
MONTHS
1.Place the indicator
2.Apply pressure to the bubble on the back of the indicator, until the bubble pops to activate the indicator.
3.Slide open the cap on the Produce Preserver housing.
4.Place the indicator in the top of the housing, facing outward.
5.Slide the cap closed, and check that the indicator is visible through the rectangular hole in the cap.
NOTE: The cap will not easily close if the indicator’s rear bubble has not been popped.
Replacing the Produce Preserver (on some models)
The disposable pouches should be replaced every 6 months, when the status indicator has completely changed from white to red.
To order replacements, see “Accessories.”
1.Remove the old pouches from the Produce Preserver housing.
2.Remove the old status indicator.
3.Install the new pouches and status indicator using the instructions in the previous sections.
10
