Install properly.. .
1.Allow 3 inches (7.5 cm] between overhead cab- inets and the refrrgerator top.
2.Allow at least an inch (2.5 cm] between the refrig- erator condenser and the wall.
3.Allow % inch (1.25 cm) on each side of the re- frigerator for ease of installation.
4.If the refrigerator is to be against a wall, you might wont to leave enough space so the door can be opened wider.
Level refrigerator-freezer...
Leveling screw
Use Screwdriver to Adjust
1.To raise front, turn each screw to the right
2.To lower front, turn each screw to the left.
3.Check with level.
Remove sales labels.. .
Remove the Consumer Buy Guide label and other inside labels before using the refrigerator. Any glue left can be taken off with rubbing alcohol.
NOTE: DO NOT REMOVE ANY PERMANENT IN- STRUCTION LABELS INSIDE YOUR REFRIGERATOR. Do not remove the Tech Sheet fastened under
the refrigerator at the front.
Clean it.. .
Clean your refrigerator before using it. See clean- ing instructions on page 8.
Plug it in...
grounding type
Refrigerator
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit serving only this appliance be provided.
Do not use an extension cord. Use a recep- tacle which cannot be turned off with a switch or pull chain. See individual electrical require- ments and grounding instruction sheet in your liter- ature package.
4