Install properly... | Remove | sales labels... | |
| Remove the Consumer Buy Guide label and any | ||
| inside labels before using the freezer | ||
| To remove | any remaining | glue: |
| 1. Rub briskly with thumb to make a ball, then | ||
| remove |
|
|
| OR |
|
|
3 inches | 2. Soak area | with drshwashing | detergent solutron (1 |
teaspoon detergent In 1 quart warm water) be- fore removing glue as described in step 1.
DO NOT USE rubbing alcohol or Rammable or toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the material.
NOTE: DO NOT REMOVE the Tech Sheet fas- tened under the freezer at the front.
1 Check the strength of the floor It should hold the weight of a fully loaded freezer
2 Pick a safe place, indoors, away from in-
flammables such as gasoline.
3 Allow 3 inches (7 5 cm] air space on top of freezer for proper ventrlatlon
4 Allow at least an Inch (2.5 cm] between the freezer condenser, on the buck of the unit, and the wall
5Allow ‘1.Inch (1.25 cm) on each side of the freezer for ease of rnstallatron
6If the freezer IS to be against a wall, you might want to leave extra space on the hinge srde so the door can be opened wider
7 The four bolts that held your freezer in the shipprng crate are designed to be the levelling legs. Screw the legs for enough into the bolt holes, in each of the four bottom corners, so the freezer stands about 1 Inch (2 5 cm] off the floor
Level freezer...
so the door WIII stay open at any positron
Levelling Leg
Lower Raise
Start adjustment with the door hinge side. 1 Slide freezer into place
2 Adjust front legs to level the freezer To rarse front, turn each leg clockwlse
~To lower front, turn each ieg
4 After freezer is fully loaded, recheck wrth level
4
Clean it ...
Clean your freezer bef using it. See cleaning rnstructions on page 6.
Plug it in...
Freezer
Power Cord
grounding plug
Recommended Grounding Method
A 115 Vo!t. 60 Hz, AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired It IS recommended that a separate circuit serving only this appliance be provrded
Do not use an extension cord. Use a recep- tacle which cannot be turned off with a switch or pull chain. See rndrvrdual electrical require- ments and grounding instruction sheet in your Irter- ature package