Install properly.. | Remove | sales labels... |
|
|
| ||||
| Remove the Consumer Buy Guide label and any | ||||||||
| inside labels before using the freezer |
| |||||||
| To remove | any | remaining | glue: |
|
|
| ||
| 1 Rub briskly with thumb to make a ball, then | ||||||||
| remove. |
|
|
|
|
|
|
| |
| OR |
|
|
|
|
|
|
|
|
| 2. Soak area with dishwashing detergent solution (1 | ||||||||
| teaspoon detergent in 1 quart warm water] be- | ||||||||
| fore removing glue as described in step I, |
| |||||||
| DO | NOT USE rubbing | alcohol | or | ftammable | or | |||
| toxic | solvents, | such | as | acetone, |
| gasoline, | car- | |
| bon tetrachloride, | etc. | These | can | damage | the | |||
| material. |
|
|
|
|
|
|
| |
| NOTE: DO NOT REMOVE the Tech Sheet fas- | ||||||||
| tened | under | the freezer | at the | front. |
| |||
1 Check the strength of the floor. It should hold the weight of a fully loaded freezer.
2.Pick a safe place, indoors, away from in-
flammables such as gasoline.
3 Allow 3 inches (7 5 cm] air space on top of freezer for proper ventilatron.
4 Allow at least an inch (2 5 cm] between the freezer condenser, on the back of the unit, and the wall
5 Allow % Inch !I.25 cm) on each side of the freezer for ease of installation
6 If the freezer IS to be against a wall, you might want to leave extra space on the hinge srde so the door can be opened wider
Level freezer...
so the door will stay open at any position
RaiseLower
I, Keep the 4 bolts that hold freezer in shipprng crate. They ore the levelling legs.
2 Screw these bolts all the way into bolt holes In the bottom corners of freezer. Move freezer into place.
3.Adjust each leg until the freezer won’t rock.
4.Adjust front legs to level the freezer
-To raise corners, turn legs in drrection shown
-To lower corners, turn legs in direction shown.
5Check with level.
Clean it...
Clean your freezer before using it. See cleaning instructions on page 6.
Plug it in...
Freezer
Power Plu
grounding plug
Recommended Grounding Method
A 115Volt, 60 Hz., AC only 15or 20 ampere fused and properly grounded electrical supply is required. It is recommended that a separate circuit serving only
this appliance be provided. Use a receptacle which cannot be turned off with a switch or pull chain. Do not use an extension cord.
4
