Whirlpool GB2SHDXPB00 manual MeatDrawerandCover, CrisperHumidityControl, CrisperandCrisperCover

Models: GB2SHDXPB00

1 40
Download 40 pages 27.43 Kb
Page 13
Image 13
MeatDrawerandCover

MeatDrawerandCover

To Remove and Replace the Meat Drawer:

1.Remove the meat drawer by sliding it out to the stop. Lift the front of meat drawer with one hand while supporting the bottom of drawer with other hand. Slide drawer out the rest of the way.

2.Replace the meat drawer by guiding it into the meat cover supports and pushing it in until it stops.

To Remove and Replace the Meat Drawer Cover:

1.Remove the meat drawer. Remove the cover by tilting up the front of the cover and lifting at the back. Pull the cover straight out.

2.Replace the cover by guiding the rear hooks into the shelf supports. Tilt the cover up at the front until the rear hooks drop into the slots.

3.Lower the front of the cover to a level position and replace the meat drawer.

Meat Storage Guide

Store most meat in original wrapping as long as it is airtight and moisture-proof. Rewrap if necessary. See the following chart for storage times. When storing meat longer than the times given, freeze the meat.

Fresh fish or shellfish

use same day as purchased

Chicken, ground beef, variety meats (liver)

...................... 1-2 days

Cold cuts, steaks/roasts

3-5 days

Cured meats

7-10 days

Leftovers - Cover leftovers with plastic wrap, aluminum foil, or plastic containers with tight lids.

To Remove the Crisper(s) Cover:

1.Remove crisper(s).

2.Holding the glass insert firmly with one hand, press up in center of glass insert until it rises above the plastic frame. Gently, slide the glass insert forward to remove.

3.Lift the cover frame up and remove it.

To Replace Crisper(s) Cover:

NOTE: Before reinstalling the cover, make sure the U-shaped reinforcement bar is reinstalled in the front edge of the crisper cover.

1.Fit back of cover frame into supports on side walls of the refrigerator and lower the front of the cover frame into place.

2.Slide rear of glass insert into cover frame and lower front into place.

CrisperHumidityControl

You can control the amount of humidity in the moisture-sealed crisper. Adjust the control to any setting between LOW and HIGH.

LOW (open) lets moist air out of the crisper for best storage of fruits and vegetables with skins.

Fruit: Wash, let dry and store in refrigerator in plastic bag or crisper. Do not wash or hull berries until they are ready to use. Sort and keep berries in original container in crisper, or store in a loosely closed paper bag on a refrigerator shelf.

Vegetables with skins: Place in plastic bags or plastic container and store in crisper.

HIGH (closed) keeps moist air in the crisper for best storage of fresh, leafy vegetables.

Leafy vegetables: Wash in cold water, drain and trim or tear off bruised and discolored areas. Place in plastic bag or plastic container and store in crisper.

CrisperandCrisperCover

To Remove and Replace the Crisper(s):

HIGH To Remove and Replace the Meat Drawer:To Remove and Replace the Meat Drawer Cover: LOW

1. Slide crisper(s) straight out to the stop. Lift the front of the crisper(s) and slide out the rest of the way.

2.Replace the crisper(s) by sliding back in fully past the drawer stop.

Utility or EggBin

Depending on your model, you may have a one, two or three piece bin. Eggs may be stored in the egg tray or loose in the bin.

NOTE: Store eggs in a covered container for long-term storage. If your model does not have an egg storage bin, store eggs in their original carton on an interior shelf.

13

Page 13
Image 13
Whirlpool GB2SHDXPB00 manual MeatDrawerandCover, CrisperHumidityControl, CrisperandCrisperCover, Utility or EggBin