Whirlpool GB2SHDXPB00 BaseGrille, Connect to Refrigerator, Complete the Installation, A B C D E

Models: GB2SHDXPB00

1 40
Download 40 pages 27.43 Kb
Page 6
Image 6
Connect to Refrigerator

6.Fasten shutoff valve to cold water pipe with pipe clamp. Be sure outlet end is solidly in the ¹⁄₄" drilled hole in the water pipe and that rubber washer is under the pipe clamp. Tighten packing nut. Tighten the pipe clamp screws slowly and evenly so rubber washer makes a watertight seal. Do not overtighten or you may crush the copper tubing, especially if soft (coiled) copper tubing is used. Now you are ready to connect the copper tubing.

7.Slip compression sleeve and compression nut on copper tubing as shown. Insert end of tubing into outlet end squarely as far as it will go. Screw compression nut onto outlet end with adjustable wrench. Do not overtighten.

8.Place the free end of the tubing into a bucket or sink. Turn ON main water supply and flush out tubing until water is clear. Turn OFF shutoff valve on the water pipe. Check for leaks. Coil copper tubing.

Connect to Refrigerator

1.Remove plastic cap from water valve inlet port. Attach the copper tube to the valve inlet using a compression nut and sleeve as shown. Tighten the compression nut. Do not overtighten. Confirm copper tubing is secure by pulling on copper tubing.

2.Create a service loop using extreme care to avoid kinks. Secure copper tubing to refrigerator cabinet with a “P” clamp.

A

B

C

D

E

Complete the Installation.

AWARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

Plug in refrigerator or reconnect power.

BaseGrille

Remove the Base Grille

1.Grasp the grille with both hands.

2.Pull the grille toward you.

Replace the Base Grille

1.See the markings on the inside of the base grille for proper placement.

2.Align the grille mounting clips with the cabinet slots.

3.Push the grille firmly into the cabinet slots until it snaps into place.

A. Copper tubing

D. Compression sleeve

B. “P” clamp

E. Water valve inlet port

C. Compression nut

 

3.Turn on water supply to refrigerator and check for leaks. Correct any leaks.

6

Page 6
Image 6
Whirlpool GB2SHDXPB00 BaseGrille, Connect to Refrigerator, Complete the Installation, Remove the Base Grille, A B C D E