Whirlpool GT1SHTXMB04 Ice Maker, Water Dispenser, Water Filtration System, Ice Production Rate

Models: ET1FHTXMQ04 ET9FHTXMT03 GC3CHAXNT00 GC3CHAXNB00 GC3CHAXNQ00 GC3CHAXNS00 GC3PHEXNT02 GC5SHEXNB00 GC3PHEXNS00 GC3PHEXNS02 GC3PHEXNQ02 GC3PHEXNB02 GC3PHEXNT03 GC5SHEXNB03 GC3PHEXNQ01 GC3PHEXNT01 GC5SHEXNQ00 GC3PHEXNQ03 GC3PHEXNB03 GC3PHEXNQ00 GC3PHEXNS03 GC3PHEXNS01 GC3PHEXNT00 GT2MHTXRS01 GT1SHTXMT04 GT2MHTXRQ01 GT2MHTXRT01 GT1SHTXMB04 GT1SHTXMQ04 GC3SHEXNQ02 GC5CHAXNQ00 GC5CHAXNB00 GC3SHEXNS02 GC3SHEXNB02 GC3SHEXNT02 GC3PHEXNB00 GC3PHEXNB01

1 32
Download 32 pages 11.31 Kb
Page 9
Image 9
Ice Maker

Ice Maker

Turning the Ice Maker On/Off

To turn the ice maker ON, simply lower the wire shutoff arm.

To manually turn the ice maker OFF, lift the wire shutoff arm to the OFF (arm up) position and listen for the click.

NOTE: Your ice maker has an automatic shutoff. As ice is made, the ice cubes will fill the ice storage bin and the ice cubes will raise the wire shutoff arm to the OFF (arm up) position. Do not force the wire shutoff arm up or down.

Ice Production Rate

Allow 24 hours to produce the first batch of ice. Discard the first three batches of ice produced.

The ice maker should produce approximately 8 to 12 batches of ice in a 24-hour period.

To increase ice production, lower the freezer and refrigerator temperature. See “Using the Controls.” Wait 24 hours between adjustments.

For maximum ice production (on some models), push the switch to ICE PLUS. The ice maker should produce 16 to 20 batches of ice in a 24-hour period in the Ice Plus mode.

Water Dispenser

IMPORTANT:

After connecting the refrigerator to a water source, flush the water system. Use a sturdy container to depress and hold the water dispenser lever for 5 seconds, then release it for

5 seconds. Repeat until water begins to flow. Once water begins to flow, continue depressing and releasing the dispenser lever (5 seconds on, 5 seconds off) for an additional 2 minutes. This will flush air from the filter and water dispensing system. Additional flushing may be required in some households. As air is cleared from the system, water may spurt out of the dispenser.

Allow several hours for the refrigerator to cool down and chill water.

Dispense enough water every week to maintain a fresh supply.

To Dispense Water:

There are two water dispenser buttons for use with different sizes of containers.

1.Press a sturdy glass against the back button or hold a container under the dispenser while pressing the front button.

2.Remove the glass or release the front button to stop dispensing.

Water Filtration System

Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts.

Remember

The quality of your ice will be only as good as the quality of the water supplied to your ice maker. Avoid connecting the ice maker to a softened water supply. Water softener chemicals (such as salt) can damage parts of the ice maker and lead to poor quality ice. If a softened water supply cannot be avoided, make sure the water softener is operating properly and is well maintained.

Do not use anything sharp to break up the ice in the bin. This can cause damage to the ice container and the dispenser mechanism.

Do not store anything on top of or in the ice maker or ice bin.

Water Filter Status Light (on some models)

The water filter status light will help you know when to change your water filter. The light will change from green to yellow. This tells you that it is almost time to change the filter. It is recommended that you replace the water filter when the status light changes to red OR water flow to your water dispenser or ice maker decreases noticeably. The filter should be replaced at least every 6 months depending on your water quality and usage.

After changing the water filter, reset the water filter status light. The status light will change from red to green when the system is reset.

Non-Indicator Water Filter (on some models)

If your refrigerator does not have the water filter status light, you should change the water filter cartridge at least every 6 months depending on your water quality and usage. If the water flow to the water dispenser or ice maker decreases noticeably before 6 months have passed, replace the water filter more often.

Using the Dispenser Without the Water Filter

You can run the dispenser without a water filter. Your water will not be filtered.

1.Remove the water filter.

2.Slide the cap off the end of the filter and replace the cap in the base grille.

IMPORTANT: Do not discard the cap. It is part of your refrigerator. Keep the cap to use with the replacement filter.

9

Page 9
Image 9
Whirlpool GT1SHTXMB04 Water Dispenser, Water Filtration System, Turning the Ice Maker On/Off, Ice Production Rate