Whirlpool GXW7330DXS MakeElectrical Connection, InstallVentCovers, CompleteInstallation

MakeElectrical Connection

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

1.Disconnect power.

2.Remove terminal box cover.

3.Remove the knockout in the terminal box and install a UL listed or CSA approved ¹⁄₂" strain relief.

4.Run home power supply wiring through ¹⁄₂" strain relief into terminal box.

E

D

C

B

A

A. UL listed wire connectors B. White wires

C. Black wires

D. Green (or bare) wire connected to yellow-green wires

E. Home power supply

5.Use UL listed wire connectors and connect white wires (B) together.

6.Use UL listed wire connectors and connect black wires (C) together.

WARNING

Electrical Shock Hazard

Electrically ground blower.

Connect ground wire to green and yellow ground wire in terminal box.

Failure to do so can result in death or electrical shock.

7.Connect green (or bare) ground wire from home power supply to the 2 yellow-green ground wires (D) in terminal box using UL listed wire connectors.

8.Tighten strain relief screw.

9.Install terminal box cover.

10.Reconnect power.

InstallVentCovers

1.When using both upper and lower vent covers, push lower cover down onto hood and lift upper cover to ceiling and install with two 2.9 x 6.5 mm screws.

NOTE: For vented installations, the upper vent cover may be reversed to hide slots.

D

C

C A

B

A. Upper vent cover

B. Lower vent cover

C. 2.9 x 6.5 mm screws

D. Bracket

CompleteInstallation

1.For non-vented (recirculating) installations only, install charcoal filters over grille on blower housing. See the “Range Hood Care” section.

2.Install metal filters. See the “Range Hood Care” section.

3.Check the operation of the range hood blower and light. See the “Range Hood Use” section.

NOTE: To get the most efficient use from your new range hood, read the “Range Hood Use” section.

9