Before You Start
Check location where hot water dispenser will be installed. Proper installation is your responsibility. Make sure you have everything necessary for correct installation. It is the responsibility of the installer to comply with installation specifications and with state and local plumbing codes.
Spout requires a
Cold water supply connection must be available. (See “Water supply requirements,” Page 5.)
Grounded electrical outlet is required. (See “Electrical requirements,” Page 5.) The outlet should be located within 42"
of hot water dispenser tank.
If spout is not to be installed in sink spray hose opening, contact a qualified installer for the best procedure for cutting a spout opening in your type of sink or countertop.
Plumbing connections must comply with all sanitary, safety and plumbing codes.
Do Not store or operate hot water dispenser below 32°F.
Do Not use pipe sealing compounds. They may get inside dispenser and cause an unpleasant taste or smell.
Water connections use quick- connect fittings which Do Not require sealing compounds to keep them from leaking.
Temperature Control must be turned to “Off” position and the dispenser tank filled before connecting to electrical supply.
This hot water dispenser is Not a water purifier. Some installations may require a water filtering system to improve the quality of water.
Important: Observe all governing codes and ordinances.
Spout installed in spray hose | If spout is not to be |
installed in sink spray hose | |
opening in sink. | opening, cut |
| |
| countertop cutout. |
Cold water
line
Tank must be mounted vertically.
42" max. — electrical outlet to hot water dispenser tank.
Saddle valve
4
