Installation Instructions cont.
NOTE: Do NOT plug power supply cord into outlet.
gasket 
4.Lay spout assembly on flat surface with coiled tubing facing up. Using one hand to hold tubing just below spout, carefully straighten tubing with other hand.
Slide gasket over tubing so that lip side of gasket is seated into base of spout.
|
| 5.Loosen square nut until it is | Hold nut, bracket, gasket and tubing |
|
| flush with end of the mounting screw. | in position and insert into hole in sink |
|
| Tip spout bracket against mounting | or counter. |
mounting |
| screw. (Bracket will form a “y” when |
|
screw |
| in the correct position.) |
|
|
|
square | bracket | |
nut | ||
|
6.Pull up on spout body to keep tension on spout mounting bracket and nut. Tighten screw inside the spout until spout is securely in position. Do not overtighten. Snap on On/Off Cap.
off position
bracket
7.Position tank vertically beneath spout so that clear tubing from spout reaches center stainless tubing on tank, and tank touches wall. Use a pencil to mark on the wall where the top of tank needs to be located. Set tank aside. Mark a second line
Position mounting bracket on wall so that bottom of mounting bracket is even with the lower line. Use two screws (and plastic anchors if attaching to dry wall) to fasten mounting bracket to wall. Hang tank on bracket.
7
