Installation Instructions cont.
| NOTE: Do NOT plug power supply cord into outlet. | |
| 8.Connect 1/4" spout tubing | NOTE: If you need to remove tubing, |
| (longer tubing) to the rear quick- | push down on collet. Pull tubing out |
| connect fitting on top of tank. Push | of |
quick- | tubing straight into fitting as far as it |
|
will go. Pull on tubing. The tubing |
| |
connect | should not come out when properly |
|
fitting |
| |
installed. |
| |
|
| |
collet | Do Not lengthen, twist or tightly |
|
| bend tubing. |
|
| 9.Connect clear tubing from spout |
|
| to center tank tubing using clamp. |
|
| Make sure clear tubing does not kink. |
|
clamp |
|
|
clear tubing
10.Install saddle valve following kit instructions. If water supply line is not copper, shut off water supply and drain line.
Drill a 1/4" hole into water supply line for the saddle valve piercing pin.
closed
11.Turn saddle valve handle clockwise 
until lance pierces soft copper tubing and valve is firmly seated. If the water line is not copper, turn the saddle valve handle clockwise until the valve is firmly seated. The valve is now in the closed position.
Place a bucket under open end of water supply line. Turn on main water supply valve to pressurize cold water line. Check for leaks.
open
12.Slowly open saddle valve and flush line into bucket to remove any foreign material that may have been trapped in the supply line during saddle valve installation.
Close saddle valve.
8
