Whirlpool KEHU309SSS Install Water Filtration System, Install Water Filter

1.Connect the 2 black wires (C) together using a UL listed wire connector.

2.Connect the 2 white wires (D) and the green (or bare) ground wire (of the oven cable) using a UL listed wire connector.

3.Connect the 2 red wires (G) together using a UL listed wire connector.

4.Install junction box cover.

Install Water Filtration System

Install Water Filter

Connect to Water Filter Inlet (yellow)

NOTE: Use the quick connect stem and/or elbow adapter fittings in the combination needed for your installation configuration.

1.Attach the supplied ³⁄₈" to ¹⁄₄" stem or ³⁄₈" to ¹⁄₄" elbow quick connect adapter fitting to the yellow water filter inlet connection by pushing the quick connect fitting past the o-ring until you hit the backstop.

AB

1.Install the water filter near the cold water supply pipe under the kitchen sink to filter the cold water.

IMPORTANT: Be sure to allow a minimum clearance of 1½" (3.8 cm) under the filter system for removing the filter cartridge.

Typical Installation Configuration

NOTE: For unique installations contact a licensed plumber

Water supply

line to oven

Cold water

supply

Hot Cold	Filter
	Assembly

Water supply

line to cold

water supply

2.Attach the supplied water filter mounting ring and screw at the recommended location.

3.Attach filter to the mounting ring.

Mounting ring and screw

1½" (3.8 cm) clearance

Connect to Home Water Supply

1.Make connection to the cold water supply line.

■A leak-tight connection to the ¼" copper tubing must be provided.

■Check local codes for type of connection required.

■Copper water supply tubing must be cut with a copper tubing cutter so the ends are concentric and without burrs.

NOTE: It is recommended that the cold water line be soft water.

A. Quick connect elbow adapter fitting

B. Quick connect stem adapter fitting

2.Connect the copper water supply tubing (not provided) from the home cold water supply pipe to the quick connect adapter fitting you just installed on the filter inlet (yellow) side of the water filter.

3.Pull tube to ensure it is secured.

A B C

A. ¼" water supply tubing

B.O-ring

C.Backstop

If you need to release tubing:

Push in collet to release tubing. With collet held in, pull tubing straight out.

A

A. Collet

Connect to Water Filter Outlet (blue)

1.Attach the supplied ³⁄₈" to ¹⁄₄" stem or ³⁄₈" to ¹⁄₄" elbow quick connect adapter fitting to the blue water filter outlet connection by pushing the quick connect fitting past the o-ring until you hit the backstop.

2.Connect another piece of copper water supply tubing to the quick connect adapter fitting you just installed on the filter

outlet (blue) side of the water filter.

6