Number Pads
Once you’ve touched a Command Pad to tell the oven what you want It to do, you’ll touch Number Pads to tell it...
Fan and Light Pads
control the
Touch Fan Pad for the desired fan speed.
(NOTE: If the temperature gets too hot around the mlcrowave oven, the exhaust tan In the vent hood will automatically turn on or change to the HIGH sefflng to protect the oven. lt may stay on up to an hour to cool the oven. When this occurs, the Fan Pad will not turn the tan off.)
Touch Light Pad for the desired
Audible Signals
Audlble signals are avallable to guide you when setting and using your oven. (A programmlng tone will sound each ttme you touch a pad. Two beeps will sound between cycles. A remtnder tone will sound every 60 seconds after cooklng Is done to remind you that something has been left in the oven. 4 beeps slgnal the end of the Minute Tlmer fun&ton.) If you don’t hear a tone, It Is because of incorrectly entered Instructions or because the tones have been removed. For example, a tone will not sound If you touch a Number Pad before you touch a Command Pad.
To remove the programmlng tone and reminder tone:
l Open the door.
l Touch CLEAR twice, then touch START.
l Programmlng and remlnder tones will be cancelled.
To replace the tones:
l Repeat the steps above.
To remove all tones:
l Open the door.
l Touch CLEAR twice, touch 0, then touch START.
l All audible tones (including Mlnute Timer signal) will be cancelled.
NOTE: Do not remove all tones If you use the Minute Timer.
To replace the tones:
l Repeat the steps above.
NOTE: It your electrlclty goes off, the tones will be replaced when the electrlclty comes back on.
Setting the Clock
When the oven Is first plugged in, a tone sounds and the Display shows “88:881’If the electric power ever goes off, the Display will again show all 8’s when the power comes back on.
You can cook or use the Minute Timer without setting the Clock, but the Display will be blank after cooklng.
DO THIS...
F!!!
1.Touch CLOCK.
THIS HAPPENS...
The Display will show a “0”and the colon will start to flash. The flrsl
Number Pad must be touched wlthln 5 seconds or the Display will go blank. If this happens, touch CLOCK again and continue.
6
