8 | . | m | . | @ |
|
|
|
|
Installation Instructions
Before you begin operating the oven, carefully read the following instructions.
1.Empty the microwave oven and clean inside it with a soft, damp cloth. Check for damage such as misaligned door, dam- age around the door, or dents inside the oven or on the exterior. if there is any damage, do not operate the unit until it has been checked by an authorized Whirlpoole service technician and any repairs made.
2.Put the oven on a cart, counter, table, or shelf that is strong enough to hold the oven and the food and utensils you put in il. (The control side of the unit is the heavy side. Use care when handling.) The weight of the oven is approximately
47 Ibs (21.15 kg). The microwave oven should be at a temperature above 50°F (10°C) for proper operation.
/
Fire,
sure To Microwave Energy, Personal
Injury and Product Damage Hazard
l Do not block the rear air intake open- ings or exhaust vents. Allow a few inches of space at back of oven where intake opening and exhaust vents are located. Blocking the air intake open- ings and exhaust vents can cause damage to the oven and poor cooking results. Make sure the microwave oven legs are in place to ensure proper airflow.
l Do not install the oven next to or over a heat source (for example, a cooktop or range) without a UL approved trim kit or without being in a UL approved built- in configuration. Also, do not install oven in any area where excessive heat and steam are generated. This could cause a fire, electrical shock, exces- sive exposure to microGave energy, other personal injury or damage to the outside of the cabinet.
Built-in kits
You can build in your microwave oven by using one of the trim kits listed on page 15.
These kits are available from your Whirlpool Dealer. If your dealer does not stock the& it can be ordered, by kii part number, by wiiting to:
Whirlpool Corporation
Attention: Customer Service Dept.
1900 Whirlpool Drive LaPorte, IN 46350
vents
8
