Programming tone
Each time you touch a pad you will hear a tone. If you don’t hear a tone, it is because the instruction is not correct, or because the tones have been removed.
EXAMPLE: If you touch a Number Pad before you touch a Command hear a tone. The instruction is not correct.
If you | want | to | remove | the | If you want | to | replace | the | ||||
programming |
| tone: |
| programming | tone: |
| ||||||
l | Open | the | door. |
|
| l | Open | the | door. |
| ||
l | Touch CANCEL | twice, | then | l | Touch | CANCEL twice. | then | |||||
| touch | START. |
|
|
|
| touch | START. |
|
| ||
l | The tone | will | not | sound for | l | The tone | will | sound for any | ||||
| any | touch. |
|
|
|
| correct | touch. |
| |||
Setting the clock
Pad, you will not
If you want to remove all tones, except the minute tlmer signal:
l Open the door.
l Touch CANCEL twice, touch 0, then touch START.
l All audible tones will be cancelled.
l To replace the tones, repeat the above steps
When the oven is first plugged in, a tone sounds and the display shows 88:88. If the electric power ever goes off, the display will again show all 8’s when the power comes back on.
You can cook or use the Minute Timer without setting the clock, but the display will be blank after cooking.
DO THIS... | THIS HAPPENS... |
I. Touch CLOCK SET.
2.Touch Number Pads for the correct time of day.
3.Touch START.
The Display will show a “0”and the colon will start to flash. The first Number Pad must be touched within 5 seconds or the Display will go blank. Touch CLOCK SETagain and continue.
The Display will show what numbers you touched in the order you touched them. This example shows 3:25.
The colon will stop flashing.The Clock is set.
If you have touched in an incorrect time, such as1265 “Err”will show on the Display. Touch CLOCK SETand start over.
NOTE: To %t the clock, touch CLOCK SET.The current time will show on the Display and the colon will flash. Continue to set the clock as shown above.
