Whirlpool RF440XL manual Adjusting the Oven Temperature Control

Put the rack(s) where you tiant them before turnrng on

		the oven.
Rack(s)	should	be	placed
so food	can be	centered		in
the oven Always leave at
least 1. z to 2 inches			(4-5	cm]
oetween the sides of the pan
and the oven walls and pans.
For more	information,		see	the
Lrrt rack a? :,ont and pull out	“Cooking		Guide.”

Set the Oven Selector on BAKE. Set the Oven Temperature Control to the baking

temperature you want

Let the oven preheat until the Signal Light goes off.

Put food in ne oven. Oven ‘OCk, wmis c c o’cmr Wiil x ho!.

6

During baking, the elements will turn on and off to help keep the oven temperature

at the setting The Signal Light will turn on and off with the elements

The top element helps heat during baking, but does not turn red

When baking is done, turn both knobs to OFF.

ADJUSTING THE OVEN TEMPERATURE CONTROL

_____

oes your new oven seem to be hotter or colder than your old oven at the

scme settings? The temperature setting in your old oven may have changed gradually over the years. The accurate setting of your new oven can seem differ- en If you think the oven temperature needs adjusting, follow these steps:

1.Pull out the center of the Oven Tem- perature Control

2.	Loosen	the	lock-	3. To lower		the		tern-
	ing screw;			perature,			move
	NOTICE	position		black	part			of
	of notches.			knob	closer			to
				LO. Each		notch
				equals	about
				10°F (5°C).
Tighten	the locking		screw.	Replace	the		knob.

4.To raise the tem- perature, move black part of knob closer to HI. Each notch equals about 10°F (5°C).

6